 |
| From Leather to........Fiberglass!!! |
| A change of pace...I purchased a Stebro dual outlet exhaust for the Lotus which necessitates making a second opening in the lower valence.....here's how! |
|
| Started by laying out the left opening so that I could duplicate it on the right...I ran a piece of tape on both sides (the numbered one) equidistant from the corner and perpendicular to the leading edge of the valence. I then put several strips of masking tape and ran a pencil over them to outline the line where the contour starts to dip...so not to cut out too much material.Then measured to line and transfered the measurements to the other side. |
 |
| All Right, this isn't a picture of fiberglass work .....but since you got this far into my site, I guess you should see whose site this is!! |
 |
|